Six-channel RF attenuator or 24-path network test system?
For level control on six separate RF lines, consider the VSA-090-06-6-UE-S. To control link levels between multiple devices using 16 RF ports, compare the 24 programmable paths of the VSA-063-06-24-UE-S with your connection plan.
6 independent channels, each on a separate RF line
24 programmable paths across 16 RF ports
Attenuation range
0–90 dB
0–63 dB
Setting step
0.5 dB
1 dB
Frequency range
50 MHz–6 GHz
50 MHz–6 GHz
Control
USB or Ethernet
USB or Ethernet
A port is a physical RF connection on the instrument. A path is a route between two connection points whose attenuation can be set. Confirm that the port pairs required by your network match the model’s connection plan.
Two examples of choosing a configuration
A six-channel test that needs 72.5 dB on one line
Suppose you are testing six separate receiver lines at 2.4 GHz and need a programmed attenuation of 72.5 dB on one line. The six-channel model’s 90 dB range and 0.5 dB step cover this setting. The published upper limit for the 24-path model is 63 dB. When assessing total measured path loss, account for insertion loss and attenuation accuracy.
At 1 GHz, suppose you want to set one defined link to 12 dB and another to 28 dB. First list the device ports forming each link. Both settings fall within the 24-path model’s range. The required port pairs must also match the system’s programmable paths.
When you need to select a signal path
To connect a common port to one of four RF paths, see the RFSW-06-SP4T-A-U-S USB-controlled SP4T RF switch. A switch selects the route a signal takes. An attenuator adjusts its level along that route.
For a quotation, share the operating frequency, your device and port list, the required port pairs, and the attenuation range and step size needed on each path.